Maybe. It depends on the cause and consistency of the reject rate. Many transdermal patch manufacturing processes produce more waste (i.e., lower yield theoretical) than other pharmaceutical processes. This should not of itself be a concern. The waste is usually due to the cumulative effect of roll splicing, line start-ups and stoppages, roll-stock changes, and perhaps higher rates of in-process sampling. This is most pronounced for processes involving lamination of rolls of various component layers. Roll-stock defects detected during adhesive coating of the roll, for example, can often only be rejected the roll after final fabrication/lamination of the entire patch, which contributes to the final process waste stream.
We expect that validated and well-controlled processes will achieve fairly consistent waste amounts batch-to-batch. Waste in excess of the normal operating rates may need (see 211.192) to be evaluated to determine cause (e.g., due to increase in sampling or higher than normal component defects... or both) and the consequences on product quality assessed. We've seen a small number of cases where unusually high intra-batch rejects/losses were due to excessive component quality variability and poorly developed processes.
